欢迎光临济南九创门业有限公司官网!

联系我们 收藏本站 在线留言

新闻资讯

首页>>新闻资讯>>电动卷帘门边角脱落的原因与解决方法?
新闻资讯
联系我们
济南九创门业有限公司

联系人:李经理

电话:15006519345

网址:www.xlmygs.com

地址:济南市天桥区北园大街372号大明家居3F-A-10

电动卷帘门边角脱落的原因与解决方法?

来源:http://www.jnhsjlm.com 日期:2020-09-27 发布人:guanli
  电动卷帘门边角脱落的原因与解决方法?
  The reason and solution of electric roller shutter door corner falling off?
  1、清洁帘布时,采用软的棉布擦拭,用硬币很容易划伤表面,污迹太重时,可以使用清洗剂、牙膏、专用清洗剂等。去污后用清水擦拭,然后擦干,正确的清洁方法能够使快速电动卷帘门始终保持亮丽如新。
  1. When cleaning the cord fabric, use soft cotton cloth to wipe it. It is easy to scratch the surface with coins. When the stain is too heavy, you can use cleaning agent, toothpaste, special cleaning agent, etc. After decontamination, wipe with water, and then dry, the correct cleaning method can make the fast electric rolling shutter door always keep bright as new.
  2、注意棱角处不要过多的擦磨,否则会造成棱角表皮层脱落。
  2. Pay attention to the edges and corners do not rub too much, or it will cause the angular epidermis to fall off.
  3、使用前应由工作人员有效调试好后,方可对门体进行运行操作。
  3. Before use, the door can be operated only after the effective debugging by professional staff.
  4、电动卷帘门体在运行的时候,门体下方禁止有小孩或物品,以免运行过程中伤到小孩或物品。
  4. When the electric rolling shutter door body is running, there are no children or objects under the door body, so as to avoid injury to children or articles during operation.
  5、在运行过程中观察是否有异常响动,如有异常噪音,需通知人士进行维护保养。
  5. Observe whether there is abnormal noise during operation. If there is abnormal noise, professionals should be informed for maintenance.
                 济南车库门
  6、当电动机的热保护连续发生动作时,应查明故障来自电动机还是超负荷或保护装置整定值太低,消除故障后,方可投入运行。
  6. When the thermal protection of the motor continuously acts, it is necessary to find out whether the fault is from the motor or overload or the setting value of the protection device is too low. After the fault is eliminated, it can be put into operation.
  7、应电动机在运行过程中良好的润滑。一般的电动机运行5000小时左右,即应补充或更换润滑脂,运行中发现轴承过热或润滑变质时,液压及时换润滑脂。更换润滑脂时,应清除旧的润滑油,并有汽油洗净轴承及轴承盖的油槽,然后将ZL-3锂基脂填充轴承内外圈之间的空腔的1/2(对2极)及2/3(对4、6、8极)。
  7. The motor shall be well lubricated during operation. The general motor runs for about 5000 hours, that is, the lubricating grease should be supplemented or replaced. When the bearing is overheated or the lubrication is deteriorated, the hydraulic pressure should change the lubricating grease in time. When replacing the grease, the old lubricating oil should be removed, and the oil groove of bearing and bearing cover should be cleaned with gasoline. Then, zl-3 lithium grease should be filled into 1 / 2 (for 2 poles) and 2 / 3 (for 4,6,8 poles) of the cavity between the inner and outer rings of the bearing.
  8、因门体始终处于扭簧拉力状态,如需修理维护等工作,需联系人士操作
  8. Because the door body is always in the state of torsion spring tension, if it needs repair and maintenance, it is necessary to contact professionals for operation
  以上就是电动卷帘门边角脱落的原因与解决方法介绍,希望对你有帮助。
  The above is the reason and solution of electric rolling shutter door corner falling off, hope to help you.

推荐阅读/ Recommended reading

车库门门板材料厚度很重要 现在的车库门大多是用铝合金材料作为而成的,车库门的厚度往往决定了整个车库门的质量的好坏。现如今大多数的车

车库门维修有哪些方法? 2021-05-13
如何对车库门电机进行日常保养维护? 2021-05-07
日常使用翻板车库门的五个好处? 2021-05-05
验收防火车库门的外观要求? 2021-04-30

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】

  • 济南九创门业有限公司