欢迎光临济南九创门业有限公司官网!

联系我们 收藏本站 在线留言

新闻资讯

首页>>新闻资讯>>工业卷帘门的轨道安装需要注意什么?
新闻资讯
联系我们
济南九创门业有限公司

联系人:李经理

电话:15006519345

网址:www.xlmygs.com

地址:济南市天桥区北园大街372号大明家居3F-A-10

工业卷帘门的轨道安装需要注意什么?

来源:http://www.jnhsjlm.com 日期:2021-03-19 发布人:guanli
工业卷帘门的轨道安装需要注意什么?
What should be paid attention to in track installation of industrial roller shutter door?
轨道是工业门开关运行的主要部件,一旦轨道焊接的不当或是变形,对工业门的整体运行都会带来不小的影响。今天小编就来说说门轨道安装的要求。
Track is the main part of industrial door switch operation. Once the track is welded improperly or deformed, it will have a great impact on the overall operation of industrial door. Today, Xiaobian is talking about the requirements of door track installation.
一般来说,工业门轨道接头可以做成直的或45度斜接头的,斜接头可使门上的大车轮在接头处平稳过渡。
Generally speaking, the track joint of industrial door can be made into straight joint or 45 degree oblique joint, which can make the big wheel on the door transition smoothly at the joint.
正常来说,轨道接头的缝隙为1-2mm,如果是在寒冷地区冬季施工或安装前的气温低于常年使用气温2℃以上时,安装工业门轨道需考虑温度缝隙,在单根钢轨长1m左右时可取4-6mm。
Normally, the gap of track joint is 1-2mm. If the temperature before construction or installation is more than 2 ℃ lower than the annual service temperature in cold area in winter, the temperature gap should be considered when installing the industrial gate track. When the single rail is about 1m long, it can be 4-6mm.
              济南车库门
此外,接头处两轨道的横向错位和高低差均应小于等于1mm。
In addition, the lateral dislocation and height difference of the two tracks at the joint should be less than or equal to 1 mm.
在同一截面上的工业门轨道面高低也会有的误差,不过这个误差也有相应的标准可言,即在柱子出不1mm在其他处不得15mm,门式起重机不得1mm,跨度大于4m的门式起重机和装卸桥不得15mm。
In the same section of the industrial gate track surface height error, but this error also has the corresponding standard, that is, in the column out of less than 1 mm, in other places should not be 15 mm, gantry crane should not be 1 mm, the span of more than 4 m gantry crane and loading bridge should not be 15 mm.
而在同一侧工业门的轨道面,在两根柱子间的标高与相邻柱子间的标高差不得B/15mm,但大不1mm。
On the track surface of the industrial door on the same side, the elevation difference between the two columns and the adjacent columns shall not be B / 15mm, but not more than 1mm.
至于轨道跨度、轨道与承轨梁、轨道不直等方面误差,以轨道安装误差表为准,切忌不能轨道安装误差表上的数值。
As for the errors of track span, track and rail bearing beam, track straightness, etc., the track installation error table shall prevail, and the values in the track installation error table shall not be allowed.

推荐阅读/ Recommended reading

车库门门板材料厚度很重要 现在的车库门大多是用铝合金材料作为而成的,车库门的厚度往往决定了整个车库门的质量的好坏。现如今大多数的车

车库门维修有哪些方法? 2021-05-13
如何对车库门电机进行日常保养维护? 2021-05-07
日常使用翻板车库门的五个好处? 2021-05-05
验收防火车库门的外观要求? 2021-04-30

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】

  • 济南九创门业有限公司