• 联系人:李经理
  • 手机:15006519345/18754165377
  • 网址:http://www.xlmygs.com
  • 地址:济南市金牛建材市场
新闻中心当前位置:首页-新闻动态
    电动卷帘门该怎么安装容易保养?
    来源:http://www.xlmygs.com  日期:2019-01-30 10:35:09
    1) 卷闸门设备方位的上端应有牢靠的防火设备,在卷闸门的卷筒下端做包箱或吊顶时有必要设置可拆式活动盖板,在电动卷门机一侧下端有必要预留500×500mm可拆检修孔,以便于维修保养。
    1) The upper end of the orientation of the rolling gate equipment should have reliable fire-proof equipment. It is necessary to install removable movable cover plate when the lower end of the rolling gate drum is used as a box or ceiling. It is necessary to reserve 500 x 500 mm removable repair holes at the lower end of the electric rolling gate machine in order to facilitate maintenance.
    2) 悉数电动操控的卷闸门,启闭作业方向有必要与开关箱指示相同,特别是在新接通电源试车或外来输入电源转化相线时.
    2) For all electrically operated rolling gates, it is necessary to operate in the same direction as that indicated by the switch box, especially when the power supply is newly connected for trial run or when the external input power is converted into phase line.
    应先运用手动设备将门帘置于门洞高度1/2 的方位,接通电源后试操作卷门启闭,直到与指示相附,方可正常运用,不然损坏限位器,引起卷帘反卷或冲顶等而形成丢掉。
    Manual equipment should be used to place the curtain in the position of 1/2 of the height of the doorway. After power supply is connected, the door of the test paper is opened and closed. The curtain can be operated normally until it is attached to the instructions. Otherwise, the limiter will be damaged and the curtain will be rolled back or flushed to the top, which will cause the curtain to be discarded.
    3) 电动卷闸门操作时,操作者有必要站在能看到卷门作业状况的方位进行操作,不然易发生意外而受损。
    3) When the electric rolling gate is operated, it is necessary for the operator to stand at the position where he can see the working condition of the rolling gate, otherwise he will be easily damaged by accidents.
    4) 卷闸门门帘和卷门机阻遏与酸、碱性物溶液接触,以防腐蚀门帘外表。

    4) The rolling gate curtain and the rolling machine prevent contact with acid and alkaline solution to prevent the appearance of the door curtain from being corroded.

    5) 卷门机在作业、滑行、传动等部位应守时检查(至少每年2次),并根据需要及时加油,以确保卷闸门的正常运用。
    5) The hoist should be inspected on time (at least twice a year) at the working, taxiing and driving parts, and refueling in time according to the need to ensure the normal operation of the hoist gate.
    6)电动卷闸门在启闭接连过程中,应具有随位接连之功用,不该有接连而持续下滑现象,如发生下滑距离大于50mm的状况出现,应立即对卷闸门操控电器和卷门机制动器进行细心检查修补,作业正常接连。
    6) In the process of opening and closing connection, the electric rolling gate should have the function of follow-up connection, not continuous slide. If the sliding distance is greater than 50 mm, the rolling gate control apparatus and the brake of the rolling gate machine should be carefully checked and repaired immediately, and the operation should be connected normally.
    7)卷闸门门帘和易锈部位,应进行守时防腐、油漆及保养处理,阻遏用重物、硬物冲击门面。
    7) The curtain and rusty parts of rolling gate shall be treated with timely anticorrosion, paint and maintenance to prevent the impact of heavy and hard objects on the facade.
    8)卷闸门作业时如有发生较大哆嗦或失常动态时应停机检查,清扫有碍门帘正常启闭的杂物。
    8) If there is trembling or abnormal dynamic during the operation of the rolling gate, stop the machine to check and clean up the debris that hinders the normal opening and closing of the door curtain.
    9)电动卷闸门底梁座上限方位有必要与轴承架下端坚持大于200mm的距离,以确保制动接连时不发生冲顶现象。
    9) It is necessary to keep a distance of more than 200 mm between the upper position of the bottom beam seat of the electric rolling gate and the lower end of the bearing rack to ensure that no top impact occurs when the brake is connected.